Gluing Spreader

Model: Introduction: Gluing machine is usually used together with cold press. There has single surface gluing and double surface gluing type.

Products Details

Technical Data

MT6106

MT6206

MT6113

MT6213

Surface Single Double Single Double
Max glue spreading width /mm 600 600 1300 1300
Max working thickness /mm 60 60 60 60
Rubber roller diameter /mm 200 200 200 200
Glue spreading speed /m/min 24 24 23 23
Motor power /kw 1.5 1.5 2.2 2.2
Overall dimension /mm 1150*800*1300 1150*970*1300 2100*900*1300 2100*1000*1300
Net weight /kg 400 400 600 600
1. The gluing spreader should be inspected every day before use. If foreign matter is found, it should be cleaned up in time to check whether the equipment is lubricated normally and whether the moving parts are running flexibly. 2. After the test run is normal, inject the glue into the glue tank, and then adjust the gap between the glue rollers according to the thickness of the veneer and the viscosity of the glue, and The gap between the glue roller and the glue roller. 3. Care should be taken to clean the surface of the veneer during the gluing process to prevent sharp debris from scratching the rubber layer on the surface of the gluing roller; the surface grooves of the rubber layer caused by long-term use should be repaired in time. 4. After a long period of shutdown and the end of daily work, in order to prevent the glue from solidifying, the gluing spreader should be thoroughly cleaned, and the glue roller, squeeze roller and glue tank should be cleaned, and the glue sprayed all over the fuselage should be cleaned. It also needs to be completely removed. After cleaning, pay attention to wipe dry water stains to prevent rust. 5. When the gluing spreader is out of service, it should be restored to the factory state; adjust the upper glue roller and squeeze roller back to the initial position, rotate the adjustment nut of the glue roller and the adjustment sleeve of the squeeze roller to adjust the glue roller The compression spring and the squeezing roller top spring are completely relaxed, and all parts are fully lubricated and equipment maintenance is carried out. Veneer gluing is an important process in the production of plywood. The quality of gluing not only affects the veneer's bonding strength and the physical and mechanical properties of the plywood, but also affects the production cost of the plywood. Therefore, mastering the structure and working principle of the veneer gluing machine and the adjustments related to the glue quality will help to use the veneer gluing machine correctly and rationally.

Contact us

Please feel free to give your inquiry in the form below We will reply you in 24 hours